CAME G4040Z Manuel D'installation page 40

Activating the radio control
Connect the RG58 cable antenna cable to the corresponding terminals .
 For TOP, TAM and TWIN series transmitters with 433.92 MHz frequency, set the AF card jumper as shown in the figure .
Fit the AF card into the control board connector .
⚠ Before fitting the AF card, you MUST CUT OFF THE MAINS POWER SUPPLY and, remove any emergency batteries.


Keep the PROG programming button pressed on the control board. The programming LED will fl ash .
Press a button on the transmitter you wish to memorize. The LED stays lit to confi rm that the transmitter is now memorized. .



PROG key
TOP TAM / TWIN
AF card
Programming LED
Programming LED