CAME G4040Z Manuel D'installation page 30

INSTALLATION
⚠ The following illustrations are mere examples. Consider that the space available in which to fit the barrier and accessories will vary depending
on the area where it is installed. It is up to each installer to select the most suitable solution.
⚠ Warning! Use hoisting equipment to transport and position the barrier.
During the set up and installing stages the barrier could be unstable and tip over. So, be careful to not lean on it until it is completely fastened.
Preparing the fastening plate.
⚠ If the flooring does not allow for a sturdy fastening of the entry unit, you will have to set up a cement slab.
Dig a hole for the foundation frame.
Set up the corrugated tubes needed for making the connections coming out of the junction pit.
 The number of tubes depends on the type of system and the accessories you are going to fit.
r 40
Set up a foundation frame that is larger than the anchoring plate and sink it into the dug hole.
Fit an iron cage into the foundation frame to reinforce the concrete.
Assemble the four anchoring brackets to the anchoring plate.
Place the plate over the iron cage.
Fill the foundation frame with concrete. The base must be perfectly level with the bolts which are entirely above surface.
Wait at least 24 hrs for the concrete to solidify.
Remove the foundation frame.