Technical Data; Before Use; Guidelines - Hilti DX 36 Mode D'emploi

Designation
36/DNI piston
Spring clip
en

5 Technical data

Right of technical changes reserved.
Tool
Weight
Dimensions (L x W x H)
Maximum fastener length
Cartridges
Power regulation
Contact movement
Contact pressure
Ambient operating temperature range
Recommended maximum fastening rate

6 Before use

NOTE
Read the operating instructions before the tool is oper-
ated for the first time.

7 Guidelines

7.1 Fastening guidelines
These guidelines must be observed at all times.
NOTE
For detailed information, please ask your local Hilti sales and service office for a copy of the applicable technical
guidelines or national technical regulations.
6
Item number
409313
3739
DX 36
2.4 kg (5.29 lb)
370 mm (14.57") × 52 mm (2.05") × 151 mm (5.94")
62 mm (2.44")
6.8/11 M (27 cal. short) green, yellow, red
3 cartridge power levels, power regulation wheel
14 mm (0.55")
140 N
-15...+50°C (+5...+122 °F)
600/h
6.1 Checking the tool 2
WARNING
Do not operate the tool when parts are damaged
or when the controls do not function correctly. If
necessary, have the tool repaired at an authorized
Hilti service center.
Check that no cartridge strip is loaded in the tool. If there
is a cartridge strip in the tool, pull it up out of the tool by
hand from above.
Check all external parts of the tool for damage and check
that all controls operate faultlessly.
Check the piston and spring clip for wear and ensure that
the parts have been fitted correctly.