MZ electronic EVVA-M Instructions D'utilisation page 27

Sensor Reset
Selecting this command sends a reset
command to all the sensors connected to the
instrument, one after the other. If the reset
has been made correctly, the word OK
appears next to the sensor number. If the
sensor is not found or does not respond, a
short line is displayed next to the sensor
number
Exit
To return to the settings menu.
Settings menu
Use the (DOWN) or
Contrast
By enabling this function it is possible to start
the display contrast programming procedure.
Light
By enabling this function it is possible to start
the display luminous intensity programming
procedure.
BackLight Time
This function allows the user to set the
backlight on time during which the display
remains lit after the last command given
(default value 30 seconds).
Keyboard Beep
This function allows the user to enable or
disable the buzzer (emitted each time a key
is pressed).
Exit
To return to the settings menu.
EVVA-M
Confirm with
Settings
C o n t r a s t
L i g h t
B k L i g h t T i m e
K e y b . B e e p
E x i t
(UP) key to move around the parameters.
Select with
Select value with
Confirm with
Select with
Select value with
Confirm with
Select with
Select value with
Confirm with
Select with
Confirm with
Confirm with
Sensor Reset
N.1=OK N.5=
N.2= - N.6=
N.3= - N.7=
N.4=OK N.8=
3 0
Ye s
= No = Yes
27
English
Rev. 01 – 2019