MZ electronic EVVA-M Instructions D'utilisation page 23

Name of the sensor
Analogic measure
Sensor name: this is the symbolic name of the sensor that can be changed in the sensor menu
with the "Sensor name" command
Sensor number: this is the sensor number, from 1 to 8, which is detected in the initial phase:
each sensor must have a univocal number: it is not possible to have two or more sensors with the
same number, as the system would not work properly.
Values measured by the sensor: the values of voltage, current and power measured by the
sensor are displayed
Alarms: here the alarm status of the display sensor is displayed. See the alarm section
From this screen it is possible to switch to the screens related to the other sensors connected (if any
existing) using the UP and DOWN buttons. For example, when 3 sensors are connected the scrolling
between the sensor pages is the following one:
Sensor 3
12.5 V
2.3 A
28 W
DOWN
The instrument Is in default condition after the first power on
EVVA-M
Sensor 1
N.1
ALARMS
V MAX
V MIN
I MAX
DATA
UP
Sensor 1
N.1
ALARMS
12.5 V
V MAX
2.3 A
V MIN
I MAX
28 W
DATA
UP
DOWN
N.1
ALARMS
12.5 V
V MAX
2.3 A
V MIN
I MAX
28 W
DATA
23
English
Number of the sensor
Alarms
Sensor 2 N.1
ALARMS
12.5 V
V MAX
2.3 A
V MIN
I MAX
28 W
DATA
UP
DOWN
Rev. 01 – 2019