General Notes - MZ electronic EVVA-M Instructions D'utilisation

General notes

The EVVA-M must be used solely for the purposes described herein. Any other use is to be considered
improper.
Any tampering with the instrument will result in immediate voiding of the warranty.
Components
The package contains:
•
Voltmeter-Amptermeter, seal and closure cover;
•
One sensor for voltage, current and power measure
•
10-pole male connector with crimp-type10 male contacts;
•
instructions for use.
Installation
(see connection diagram)
Warning
ALWAYS DISCONNECT THE BATTERY PRIOR TO INSTALLATION.
•
The voltmeter must be positioned so that the display will be easy to read. It should not be
exposed to direct sunlight.
•
The rear part of the instrument must be protected from contact with water or moisture.
•
The instrument may be fastened to dashboards of any thickness. The screws used for clamping
must be of the self-threaded kind and with a diameter of 3.5 mm (~9/64") and a maximum
length of 10 mm plus the thickness of the dashboard.
•
In the part to the rear of the dashboard there must be minimum clearance of 35 mm (1" 3/8) and
there must also be adequate access to perform installation and maintenance work.
•
On the dashboard make a hole with a diameter of 30 mm (~ 1" 3/16), as indicated, and 4 holes
with diameters of 4 mm (~5/32") for the chain counter clamping screws. Use cutting nippers to
cut the three pins on the back of the instrument, position the chain counter and fasten it to the
dashboard by tightening the four screws. If the dashboard already has a hole with a 54 mm
(2"1/8) diameter, it is not necessary to cut the pins on the back.
•
The seal must be positioned between the chain counter and the dashboard.
EVVA-M 19
English
Rev. 01 – 2019