BWT AQA total Energy 5600 Instructions D'installation Et D'utilisation page 26

EN
5.4.3. Attach AQA total supply distributor
to mounting hooks as shown in diagram
and secure with supplied screws.
5.4.4.Connect the AQA total supply distributor
Connection options
The AQA total unit water supply can be fed in from
either direction. The water outlet can also be on eit-
her side of the unit.
Variant 1
Input
Output
Variant 3
Input
Output
Important:
The water inlet must always be on the back of the
unit. Note the "IN" sticker on the AQA total supply
distributor.
The water outlet must always be on the front of the
unit. Note the "OUT" sticker on the AQA total supply
distributor.
The scope of delivery includes:
• 2 grub screw connections each consisting of a
plate, locking nut and flat seal
• 2 screw connections each consisting of a
screw, locking nut and flat seal
- AQA total 5600 6/4" external thread
- AQA total 8400 6/4" external thread
- AQA total 11200 2"
- AQA total 14000 2"
26
Variant 2
Input
Output
Variant 4
Input
Output
external thread
external thread
Connect the AQA total supply distributor
while switched off with the pipes using
the supplied screw connections.
The vacant, open connections of the
AQA total supply distributor should be
sealed with the grub screws.
The wall distance can be
modified within a certain ran-
ge by loosening the pre-fixed
fixing screws so that the
unit is mounted without any
stresses.
5.4.5. Take the working unit included in the
scope of delivery out of the packaging
and remove the transportation sealing caps.
Connect the working unit to the
AQA total supply distributor.
I. Turn the retaining ring to the left
until the stop is reached.
II. Press the working unit claws into
the slots until the stops are reached.
III. Turn the working unit clockwise
45° until the stop is reached.
IV. Pull the retaining ring with both
hands in the direction of the
working unit until it engages. The
working unit is now secured
against unintentional rotation.
To release the rotation safety, press both clips on
the retaining ring together and push upwards with
both hands.
5.4.6. Plug the electrode cable, using the plastic
plug, into the underside of the working unit.
Important: Numbers are displayed on the cable
channel and plastic plug.