Testing Your Blood Glucose; Preparing The Lancing Device - Fora Diamond MINI Mode D'emploi

• When Beep is turned off, the alarm function will remain
effective.
• During memory deletion, select "
results.
• You may set it up to four reminder alarms.
• To turn off an alarm, find the alarm number by pressing
SET, then press MAIN to toggle On to OFF.
• When the alarm goes off, the device will automatically
turn on. Press MAIN to mute the alarm. If you do not press
MAIN, the device will beep for 2 minutes then switch off.
• If the device is idle for 2 minutes during the setting mode,
it will turn off automatically.

Testing Your Blood Glucose

Test Strip Appearance
Absorbent Hole
Apply a drop of blood
here. The blood will be
automatically absorbed.
Test Strip Handle
Hold this part to insert
the test strip into the slot.
" to keep all saved
Confirmation Window
This is where you confirm
if enough blood has been
applied to the absorbent hole
in the strip.
Contact Bars
Insert this end of the test strip
into the meter. Push it in firmly
until it will go no further.
Inserting a Test Strip
Insert the test strip into its slot.
Important!
The front side of test strip should face up when inserting the
test strip. Test results might be wrong if the contact bar is not
fully inserted into the test slot.
Important!
To reduce the chance of infection:
• Never share a lancet or a lancing device.
• Always use a new, sterile lancet. Lancets are for single use
only.
• Avoid getting hand lotion, oils, dirt, or debris in or on the
lancets and the lancing device.

Preparing the Lancing Device

1. Remove the cap.
2. Insert a new lancet firmly into the white lancet holder cup.
3. Remove the protective disk on the lancet.
Hold the lancet firmly in place and twist off the protective
disk.
EN-4