Oven Care; Self-Cleaning Cycle - KitchenAid KEBU107 Guide D'utilisation Et D'entretien

Fours électriques à convection simples et doubles, encastrés et à injection de vapeur
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNING
Burn Hazard
Do not touch the oven during the Self-Cleaning cycle.
Keep children away from oven during

Self-Cleaning cycle.

Failure to follow these instructions can result in burns.
IMPORTANT: The health of some birds is extremely sensitive to
the fumes given off during the Self-Cleaning cycle. Exposure to
the fumes may result in death to certain birds. Always move birds
to another closed and well-ventilated room.
Self-clean the oven before it becomes heavily soiled. Heavy soil
results in longer cleaning and more smoke.
Keep the kitchen well-ventilated during the Self-Cleaning cycle to
help get rid of heat, odors, and smoke.
Do not block the oven vent(s) during the Self-Cleaning cycle. Air
must be able to move freely. Depending on your model, see
"Oven Vent" or "Oven Vents" section.
Do not clean, rub, damage or move the oven door gasket. The
door gasket is essential for a good seal.
Prepare Oven:
Remove the broiler pan, grid, cookware and bakeware and,
on some models, the temperature probe from the oven.
Remove any foil from the oven because it may burn or melt,
damaging the oven.
Remove oven racks to keep them shiny and easy to slide.
See "General Cleaning" section for more information.
Hand clean inside door edge and the 1½" (3.8 cm) area
around the inside oven cavity frame, being certain not to
move or bend the gasket. This area does not get hot enough
during self-cleaning to remove soil. Do not let water, cleaner,
etc. enter slots on door frame. Use a damp cloth to clean this
area.
Wipe out any loose soil to reduce smoke and avoid damage.
At high temperatures, foods react with porcelain. Staining,
etching, pitting or faint white spots can result. This will not
affect cooking performance.
How the Cycle Works
IMPORTANT: The heating and cooling of porcelain on steel in the
oven may result in discoloring, loss of gloss, hairline cracks and
popping sounds.
The Self-Cleaning cycle uses very high temperatures, burning soil
to a powdery ash.
The oven is preset for a 3 hour 30 minute clean cycle, however
the time can be changed. Suggested clean times are 2 hours
30 minutes for light soil and between 3 hours 30 minutes and
4 hours 30 minutes for average to heavy soil.

OVEN CARE

Self-Cleaning Cycle
Use the following chart as a guide to determine the desired
cleaning level.
CLEANING
LEVEL
1 (Quick)
2
3
4 (Regular)
5
6 (Maxi)
Once the oven has completely cooled, remove ash with a damp
cloth. Do not wipe down any of the inside surfaces until the oven
has completely cooled down. Applying a cool damp cloth to the
inner door glass before it has cooled completely could result in
the glass breaking.
The oven lights will not work during the Self-Cleaning cycle.
On double oven models, only one oven can self-clean at a time. If
one oven is self-cleaning, the other oven cannot be set or turned
on.
NOTE: The oven has a 2 speed cooling fan motor. During self-
cleaning the fan(s) will operate at its highest speed to increase
airflow to better exhaust the hotter air through the oven vent(s).
An increase of noise may be noticeable during and after the self-
cleaning cycle until the oven cools.
To Self-Clean:
Before self-cleaning, make sure the door is closed completely or
it will not lock and the cycle will not begin.
1. From the Main menu, touch MORE.
2. Touch SELF CLEAN.
3. Touch + or - to increase or decrease the clean time to the
desired level.
4. Touch TIPS to receive instructions on preparing your oven for
self-clean. Touch OK to return to the Self-Clean menu.
5. Once the self-clean setup function is complete, the Start key
will light up.
6. When settings are correct, touch START.
7. When the end of the self-clean time is reached, the oven will
shut off automatically and the Complete message will be
displayed. If enabled, end-of-cycle tones will sound, then
reminder tones will sound every minute. Touch OK to clear
this message, stop reminder tones and return to the Main
Menu.
To Delay Start Self-Clean:
1. From the Main menu, touch MORE.
2. Touch SELF CLEAN.
3. Touch + or - to increase or decrease the clean time to the
desired level.
4. Touch TIPS to receive instructions on preparing your oven for
self-clean. Touch OK to return to the Self-Clean menu.
5. Touch OFF DELAY.
TOTAL CLEANING TIME
(includes a 30 minute cool down time)
2 hours
2 hours 30 minutes
3 hours
3 hours 30 minutes
4 hours
4 hours 30 minutes
31

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Kebu208

Table des Matières