Installation Instructions; Installation - Vented To The Outside; Step 1, Mount Template; Step 2, Install Upper Support Frame - Monogram ZV850 Instructions D'installation

INSTALLATION – VENTED TO THE OUTSIDE
MOUNT TEMPLATE
tape in place.
– Be sure the template is oriented correctly, with the
front of the hood.
Use a plumb to be sure the mounting holes will provide
parallel alignment with the countertop below.
locations. Use a 5/32" bit and drill
approximately 1-1/2" deep.
1" dia.
" duct opening
through the ceiling.
INSTALL UPPER SUPPORT FRAME
joists and/or cross framing with the 4 screws
provided. For maximum rigidity and strength, the
screws must be driven into the center of the joists
and/or cross-framing.
vertically and horizontally.

Installation Instructions

Front of Hood
12
INSTALL LOWER SUPPORT FRAME
frame and loosely secure with 8 screws and
washers (4 on the front and 4 on the back sides).
Adjust the lower support frame up or down
to the desired height above the countertop.
Tighten screws.
24" Minimum
30" Maximum
IMPORTANT: Again, check to be sure the support is
level in both directions. There is no way to level the
hood after the hood is secured to the frame.
13-5/8 "