Gold 5/16" Flat Head Screw; Black 1-1/4" Flat Head Screw; Brown 1-1/2" Flat Head Screw; Black 7/8" Machine Screw - Sauder Palladia Serie Mode D'emploi

Step 3
NOTE: Before beginning this step, separate the NARROW EXTENSION SETS (40NA and 40NC) from the WIDE
å
EXTENSION SETS (40MA and 40MC). Do not confuse these SETS once they are separated.
Separate the NARROW EXTENSION SLIDES (40NC) from the NARROW EXTENSION RAILS (40NA) as shown in the
å
upper diagram below. Be prepared, the parts are greasy.
Fasten the NARROW EXTENSION SLIDES (40NC) to the KEYBOARD SIDES (YY and ZZ). Use two GOLD 5/16" FLAT
å
HEAD SCREWS (3S) through hole #3 and use two BROWN 1-1/2" FLAT HEAD SCREWS (14S) through hole #1 and into
the KEYBOARD BACK (XX).
Then, fasten the KEYBOARD BACK (XX) to the KEYBOARD SHELF (AAA). Use two SMALL BLACK 1-1/4" FLATHEAD SCREWS (74S).
å
Fasten the KNOB (42K) to the KEYBOARD FRONT (WW). Use a BLACK 7/8" MACHINE SCREW (37S).
å
Push the black lever in and pull the SLIDE from the RAIL.
2
3

BLACK 7/8" MACHINE SCREW

(1 used for the KNOB)
www.sauder.com/services
40NC
Open end
1
ZZ
42K
37S
If the KEYBOARD BACK
has an unfi nished surface,
it should be facing here.
AAA
WW

GOLD 5/16" FLAT HEAD SCREW

(2 used for the fi rst holes in the SLIDES)
417714
40NA
SMALL BLACK 1-1/4" FLAT HEAD SCREW
(2 used for the KEYBOARD BACK)

BROWN 1-1/2" FLAT HEAD SCREW

(2 used for the #1 holes in the SLIDES)
XX
YY
2
3
3S
74S
14S
Open end
1
Page 9