Black 9/16" Large Head Screw; Gold 5/16" Flat Head Screw - Sauder Executive Desk 412902 Instructions De Montage

Step 4
Separate the WIDE EXTENSION SLIDES (DDD) from the WIDE EXTENSION RAILS (CCC) as shown in the upper diagram
å
below. Be prepared, the parts are greasy.
Fasten the WIDE EXTENSION RAILS (CCC) to the ENDS (B3 and C3) and UPRIGHTS (D2 and E2). Use twelve GOLD
å
5/16" FLAT HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other holes that line up with the holes in the ENDS and UPRIGHTS. Turn a
SCREW into this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Fasten four ANGLE BRACKETS (27G) to the RIGHT END (B3) and RIGHT UPRIGHT (D2). Use four BLACK 9/16" LARGE
å
HEAD SCREWS (1S).
NOTE: Be sure the edges
å
of the ANGLE BRACKETS
are even with the edges of
the END and UPRIGHT.

GOLD 5/16" FLAT HEAD SCREW

(12 used in this step)
Open end
www.sauder.com/services
DDD
Push the black lever in and pull the SLIDE from the RAIL.
3S
C3
CCC
Open end
E2
D2
CCC
412902
CCC
Open end
CCC
B3

BLACK 9/16" LARGE HEAD SCREW

(4 used for the ANGLE BRACKETS)
Open end
CCC
27G
(4 used)
27G
1S
Page 11