Sauder Palladia Serie Mode D'emploi page 20

Step 14 Step
Fasten the NARROW EXTENSION RAILS (40NA) to the INNER ENDS (B3 and D3) and UPRIGHTS (E2 and F2). Use eight
å
GOLD 5/16" FLAT HEAD SCREWS (3S) through holes #1 and #3 in four RAILS that fasten to the INNER LEFT END (D3)
and LEFT UPRIGHT (F2). Use four GOLD 5/16" FLAT HEAD SCREWS (3S) through holes #1 and #4 in two RAILS that
fasten to the INNER RIGHT END (B3) and RIGHT UPRIGHT (E2).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the END and UPRIGHT. Turn a
SCREW into this hole.
3
2
1
1
Open end
When this NARROW
EXTENSION RAIL (40NA) is
fastened to the UPRIGHT (E2),
it will hang over the edge.
Page 20
4
4
3
2
D3
1
Open end
1
2
3
4
2
3
4
F2
4
3
2
E2
417714
When this NARROW
EXTENSION RAIL (40NA) is
fastened to the UPRIGHT (F2),
it will hang over the edge.
Open end
1
GOLD 5/16" FLAT HEAD SCREW
(12 used in this step)
Open end
1
2
3
4
B3
3S
www.sauder.com/services