Table des Matières
Publicité
Step 55
Step
Before fastening the DOOR to your unit, be sure the mounting
å
screw is against the stops as shown in the right diagram. If it isn't,
loosen the mounting screw to slide it against the stops. Then
tighten the mounting screw.
Fasten the DOOR (P) to the INNER RIGHT END (B3). Use the
å
screws in the HINGES. See the next step for door adjustments.
Peel a FELT DISC from the FELT DISC CARD (1M) and stick it on the
å
DOOR where it comes in contact with the RIGHT UPRIGHT (E2).
Fasten a KNOB (42K) to the DOOR (P). Use a GOLD 1"
å
MACHINE SCREW (50S).
www.sauder.com/services
B3
E2
417714
KEYBOARD
DRAWER ON LEFT
Stop
Mounting
screw
Hinge
1M
42K
P
1M
50S
GOLD 1" MACHINE SCREW
(1 used for the KNOB)
Page 61
Publicité
Table des Matières
