Table des Matières
Publicité
Step 43
Step
Fasten the NARROW EXTENSION RAILS (40NA) to the other surface
å
of the LEFT UPRIGHT (F2) and KEYBOARD UPRIGHT (VV). Use four
GOLD 5/16" FLAT HEAD SCREWS (3S) through holes #1 and #3.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole
å
shown in the enlarged diagram. Then, slide the inner cartridge of
the EXTENSION RAIL in to fi nd the other hole that lines up with the
holes in the UPRIGHTS. Turn a SCREW into this hole.
Open end
1
www.sauder.com/services
4
3
2
F2
3
4
VV
Surface without
TWIST-LOCK®
FASTENERS
GOLD 5/16" FLAT HEAD SCREW
417714
KEYBOARD
DRAWER ON LEFT
Open end
1
Finished edge
2
3S
(4 used in this step)
Page 49
Publicité
Table des Matières
