Maintenance And Cleaning; Cable Assembly; Material Damage; Torch Body - Abicor Binzel ABIPLAS WELD 100 W Mode D'emploi

9 Maintenance and cleaning

9.1 Cable assembly

9.2 Torch body

EN - 20
Clean the cable assembly by proceeding as follows:
1 Check threaded fittings and plug-in connections for visible damage and
tight fit and replace them if necessary.
WARNING
Risk of injury
Serious injuries may be caused by parts swirling around.
• When cleaning the wire guide with compressed air, always wear
personal protective clothing, in particular safety goggles.
CAUTION

Material damage

Impurities destroy the inside of the welding torch.
• Never blow compressed air into the nozzles from the front.
2 Clean lines by blowing compressed air through them from behind.
1 Remove the gas nozzle.
2 Remove weld spatter.
NOTICE
• Replace the centring ceramics as soon as deposits become visible on the
surface. Deposits may result in high-voltage flashovers that destroy the
torch body.
3 Check the wear parts for visible damage and replace them if necessary.
4 Unscrew the back cap and remove the tungsten electrode.
5 Sharpen the tungsten electrode as follows:
Sharpening the tungsten electrode depends on wear and must therefore be
carried out when required.
®
ABIPLAS WELD
BAL.0092 • 2021-08-20