Abicor Binzel ABIPLAS WELD 100 W Mode D'emploi page 37

®
ABIPLAS WELD
7 Operation
BAL.0092 • 2021-08-20
DANGER
Shortness of breath and poisoning caused by inhaling
phosgene gas
When welding workpieces that have been degreased with chlorinated
solvents, phosgene gas is formed.
• Do not inhale fumes and vapours.
• Ensure a sufficient supply of fresh air.
• Rinse workpieces with clean water prior to welding.
• Do not place degreasing baths containing chlorine in the vicinity of the
welding area.
DANGER
Risk of burns
During welding activities, sparks, glowing workpieces or hot slag can
produce flames.
• Check the work area for flashpoints.
• Provide suitable fire extinguishing equipment at the workstation.
• Allow workpieces to cool down after welding.
• Prior to performing welding work, properly fasten the ground clamp to
the workpiece or the welding table.
WARNING
Arc eye
The arc produced by welding can damage the eyes.
• Wear your personal protective equipment.
• Check the personal protective equipment before every cutting process.
NOTICE
• The device must only be operated by qualified personnel (in Germany,
see TRBS 1203).
• Ensure that all required parameters for your welding task, for example
welding current, wire feed etc., have been set at the welding power
source.
• Check the actual gas flow on the measuring instruments or by closing
and opening the corresponding gas outlet openings on the torch.
7 Operation
EN - 17