Maintenance And Cleaning - Abicor Binzel ADF 600S Mode D'emploi

9 Maintenance and cleaning

9 Maintenance and cleaning
Despite the above, scheduled maintenance and cleaning are prerequisites for a long service life and fault-
free operation.
NOTICE
• Maintenance and cleaning work may only be carried out by qualified personnel (in Germany, see
Check the following:
Clean the ADF 600S daily, as well as whenever it is to be worn by a different user and whenever it is
soiled.
 Fig. 10 Cleaning automatic filter, solar cells and sensors on page EN-16
Automatic filter (1):
Daily
Solar cells (2) / sensors (3):
Helmet shell (4):
Replace outside viewing pane (2):
As needed/in case of
damage (broken, Replace inside viewing pane (4):
scratched, dirty, etc.)
Replace automatic filter (2):
Tab. 10 Maintenance and cleaning
9.1 Cleaning the automatic filter, solar cells, sensors and helmet shell
1 Automatic filter
Fig. 10 Cleaning automatic filter, solar cells and sensors
EN - 16
All manuals and user guides at all-guides.com
TRBS 1203).
2 Solar cells
1 Wipe off the surface with a soft cloth. Do not use any strong
solvents.
2 Wipe off the solar cells / sensors with methylated spirits and a
clean cloth. Then wipe off with a dry, lint-free cloth.
3 Use a soft cloth and soapy water to wipe down and disinfect
the helmet shell.
 6.1 Removing protective film / replacing viewing pane on
page EN-9
 6.1 Removing protective film / replacing viewing pane on
page EN-9
 Fig. 11 Replacing the automatic filter on page EN-17
1
4
3 2 sensors
ADF 600S
2
3
4 Helmet shell