®
ABIPLAS
WELD
6.3 Connecting the coolant
1
4
1
Coolant return hose
2
Coolant supply hose
Fig. 6
Connecting the coolant
BAL.0092 • 2021-08-20
WARNING
Risk of burns
If the coolant level is too low, the plasma welding torch will overheat.
• Wear the correct protective gloves.
• Check the coolant level at regular intervals.
NOTICE
• Ensure that the coolant supply and return hoses have been correctly
installed. Coolant supply = blue, coolant return = red.
• Do not use deionised or demineralised water as coolant or for leak and
flow tests.
This may shorten your welding torch's service life.
• For liquid-cooled welding torches, we recommend using
ABICOR BINZEL BTC coolant.
Please consult the applicable safety data sheet.
2
3
Coolant recirculator
4
Control lead
6 Putting into operation
3
EN - 15