Cleaning The Filter - AERMEC CHF 17 Manuel D'utilisation Et D'installation

USE
Deflector fin
Adjust the deflector until it is in the required position
Push the lower part to increase the opening
Once the required position has been obtained, you can fix it by tightening the side screws that regulate the friction.
WARNING: continuously altering the deflector fin opening may slacken the friction. In this case, adjust the regulating screws.
MAINTENANCE

Cleaning the filter

To clean the filter, refer to the fan coil manual.
To access the filter, remove the front panel, rotate the two stops
by 90°, then take out the fan coil filter as shown in the figure.
After cleaning the filter, reassemble it in its seat, lock it in
place with the two stops, then replace the front panel.
Push the upper part to reduce the opening
Warning: if the filter is badly damaged, it must be replaced
immediately. The fan coil must not operate without a filter.
ACHFUJ 1103 - 4689580_01
11