Important Information And Maintenance; Extraordinary Cleaning; During Operation; Operation Anomalies - AERMEC VED 030I EU Manuel Technique

IMPORTANT INFORMATION AND
MAINTENANCE
ATTENTION:
The fan coil is connected to the power sup-
ply and the hydraulic circuit. Operations
performed by persons who do not have the
required technical skills can lead to personal
injury to the operator or damage the unit
and the surrounding environment.
Supply the fan coil only with voltage 220V
~ 60Hz. The fan coil may be permanently
damaged if a different electric power supply
is used.
DO NOT USE THE FAN COIL IMPROPERLY
The fan coil must not be used to breed, deliv-
er and raise animals.
AIR OUT THE ROOM
Periodically air out the room in which the
fan coil has been installed; this is particu-
larly important if the room is occupied by
many people, or if there are gas appliances
or sources of odours.
ADJUST THE TEMPERATURE CORRECTLY
Ambient temperature should be regulated
to ensure maximum comfort, particularly
for the elderly, infants and invalids. Prevent
temperature fluctuations between indoors
and outdoors greater than 7°C/44.6°F dur-
ing summer. Excessively low temperatures
during summer involve higher electrical con-
sumption.
DIRECT THE AIR FLOW CORRECTLY
Air delivered by the fan coil must not be
directed onto people. Even if the air tem-
perature is higher than the ambient tem-
perature, it can cause a cold sensation and,
therefore, discomfort.
AIR FILTER REMOVAL AND REASSEMBLY
To clean the air filter remove it from the fan
coil.
The clean or new (replaced) air filter must be
mounted and locked in place properly in the
fan coil.
To remove the air filter:
- loosen the screws of the two filter retainers
- make the two filter retainers slide all the
way
- pull the filter out of its seat
To remount the clean air filter:
- insert the air filter into its seat,
- make the two filter retainers slide until
locking the filter in place,
- tighten the screws of the two filter retainers,
- make sure that the filter is locked in place.
IVEDITI 0121 4880985_00
4
DO NOT USE WATER THAT IS TOO HOT
Use soft cloths or sponges soaked in warm
water (no higher than 40 °C/104°F) to clean
the fan coil. Do not use chemical products or
solvents to clean any part of the fan coil. Do
not spray water on internal or external sur-
faces of the fan coil (danger of short circuits).
CLEAN THE FILTER PERIODICALLY
Frequent cleaning of the filter will ensure
more efficient operation. Check if the filter is
excessively dirty. Repeat the operation more
frequently, if required. Clean often and use a
suction device to remove accumulated dust.
When the filter is clean, reassemble it onto
the fan coil by following the removal proce-
dure in reverse order.

EXTRAORDINARY CLEANING

Removing the augers of the inspected fans
(which can be carried out only by qualified
personnel) allows the internal parts to be
cleaned accurately. This is essential for instal-
lation in very crowded areas or that require
high hygienic standards.

DURING OPERATION

Always leave the filter mounted on the fan
coil during operation, otherwise the dust in
the air will dirty the surface of the coil.
When in cooling mode, water vapour can
come out of the fan coil air flow. When in
heating mode, a slight hissing sound can be
heard near the fan coil. The fan coil may
sometimes emit unpleasant odours due to
the accumulation of substances present
in the environment (clean the filter more
often, especially if the room is not aired out
regularly). During operation, noise and/or a
creaking sound may be heard from inside the
device due to the heat expansion of the ele-
ments (plastic and metal), however, this does
not indicate a fault and does not cause dam-
age to the unit unless the maximum input
water temperature is exceeded.

OPERATION ANOMALIES

In case of anomalous operation, disconnect
the voltage from the unit and then re-apply it
and re-start the appliance.
ATTENTION! Do not try to repair the unit
on your own, as it may be very dangerous! If
the problem persists, call the Area After-sales
Service immediately.
DO NOT PULL THE ELECTRIC CABLE
It is very dangerous to pull, step on or crush
the power supply cable or secure it using
nails or staples. The damaged cable can
cause short circuits and injury to persons.
Do not introduce objects into air vents
Do not introduce objects in the air outlet
and inlet.
This could cause injury to persons or dam-
age the fan.
ATTENTION
The appliance can be used by children over
the age of 8 and by people with reduced
physical, sensory or mental capabilities or
without experience or necessary knowledge,
as long as they are supervised or have been
instructed on the safe use of the appliance
and on the understanding of the dangers
inherent to it. Children must not play with
the appliance. Cleaning and maintenance
must be carried out by the user and not by
unsupervised children. Please also note that
the unit must not be used by children as a
toy
only version EU UTH ETL
only version EUW EUWP