Service & Maintenance; Frequently Asked Questions; Warranty Terms And Conditions - Bahco BBAGM Serie Traduction Des Instructions Originales

BBAGM SERIES
4. OPERATING INSTRUCTIONS
Always wear safety equipment before trying to jump start your vehicle. Make sure the area is well ventilated and
that the terminals are clean.
Also make sure that your unit is fully charged before attempting to jump start.
If you have a 12/24V unit, make sure that the voltage selector switch is on "OFF" or that the red voltage connector
plug is unplugged. If you have a 12V (or 24V) unit with ON\OFF switch, make sure it is turned OFF. Please also make
sure that the cables are not in the path of moving parts in the vehicle's engine bay.
The battery terminal not connected to the frame should be connected first. The other terminal should be connected
to the frame, far from the battery and the fuel line. After starting, remove the frame connexion first, then the con-
nexion from the battery in the same order.
Please turn OFF the air conditioning, the radio and the lights before jump starting.
1. Connect the positive (red) clamp to the positive terminal.
2. Connect the negative (black) clamp to the frame of the vehicle (ground).
3. If you have a 12/24V unit, choose the voltage with the voltage selector switch or with the voltage connector plug
12V or 24V. If you have a 12V or 24V unit with ON/OFF switch, turn it ON.
4. Then start your engine and stay clear of the battery and the Start Booster while jump-starting. Make sure that it
cannot fall inside the engine compartment.
5. Once started, first disconnect the black (negative) clamp, then place the voltage selector switch on OFF; or
unplug the voltage connector plug from the 12/24V unit.
6. Then disconnect the red (positive) clamp.
7. Store both clamps immediately in their respective placing.
8. Recharge the Jump Starter with the supplied automatic charger.
Important: Should the vehicle refuse to start within 10 seconds, have the Start Booster cool down for 3 min-
utes before the next attempt. If it still doesn't start, have your car battery or engine checked. It may be that
the car battery is defective as well and refuses to accept the current from the Jump Starter.
This Start Booster can also be used as a source of power. For example, you can use a 12V OBD Memory Saver
cable or 12V LED lights which you can connect to the socket of the Booster. Please always recharge the Start
Booster after use.
5. SERVICE & MAINTENANCE
No special maintenance is needed on any of the Start Boosters. The most important is to always make sure that
your Battery Start Booster or Hybrid Start Booster is always fully charged. Keeping your unit discharged would
damage it and void the warranty. Please also only use the supplied battery charger to recharge it. Do not try to open
the unit yourself. Have an authorized agent do it for you. Keeping your unit clean and stored at room temperature
would be best. Extreme temperatures will damage the batteries. When not in use for an extended period of time,
always make sure it is fully charged at least once a month.

6. FREQUENTLY ASKED QUESTIONS

My Start Booster doesn't have power at the clamps.
Please check the On/Off switch, the 12/24V connector or that the Safety Fuse has not burst. It could be that the
connector is not connected properly.
The Booster is not taking the charge.
Please check the fuse inside the charger or the tip of the charger. Please also check that the charger is working by
checking its voltage output on the tip with a voltmeter.

7. WARRANTY TERMS AND CONDITIONS

https://www.bahco.com/int_en/warranty
EN