Setup Alc; Illuminat; Contrast; Al. Beep - ROBBE ALC 8500-2 Expert Instructions D'utilisation

CyCy NiMH
Maximum cycle count for NiMH batteries in the "Cycle" function; variable in the range 2 to 20 cycles
CyFo NC
Maximum cycle count for NC batteries in the "Form" function; variable in the range 2 to 20 cycles
CyFo NiMH
Maximum cycle count for NiMH batteries in the "Form" function; variable in the range 2 to 20 cycles
Restore
If you select "Restore" and confirm it by pressing the "OK / Menu" button, all charge / discharge
parameters are returned to the standard default values.
Return
"Setup ALC" is a further sub-menu within the configuration menu of the ALC 8500-2 Expert. Confirm
your selection with the "OK / Menu" button, and the menu points shown in Fig. 30 are available.

14.3 Setup ALC

"Setup ALC" is a further sub-menu within the ALC 8500-2 Expert's Configuration menu. Confirm your
selection with the "OK / Menu" button, and the menu points listed in Fig. 30 are available:
Return? Illumin?
Fig. 30: Menu points in the "Setup ALC" menu

14.3.1 Illuminat.

In this menu (Fig. 31) you can set the duration of the display backlighting in active mode after the last
operation of the controls (buttons, jog dial). The times available are: 1
minute, 5 minutes, 10 minutes, 30 minutes and 60 minutes. It is also
possible to switch the backlighting on or off permanently.

14.3.2 Contrast

Calling up this menu enables you to set the screen contrast to any of
sixteen values, and store your preference (see Fig. 32).

14.3.3 Al. Beep

The ALC 8500-2 Expert is fitted with an audible sounder which emits
various alarm signals if limit values are exceeded, if an error occurs
and after the conclusion of various functions. At this menu point you
can switch the sounder function on and off.

14.3.4 But. Beep

When the "Button Beep" function is active, the charger emits a brief
audible beep every time you press a button or turn the jog dial (incre-
mental control).
AL. Beep?
Contrast?
53
But.Beep? Return?
Fig. 31: Setting the time for
screen backlighting
Fig. 32: Setting the screen
contrast