Connection Settings On The Computer; Connecting To A Computer - Epson EasyMP EMP-7850 Guide De Mise En Route

Connecting in Access Point Mode or Wired LAN Connection Mode

Connection Settings on the Computer

Computer connection setup is performed using the utility software provided with
the LAN card.
If these settings are already established, this step need not be performed.
Refer to the documentation for the LAN card for instructions on how to use the
utility software.
Establish settings enabling the computer to function on the network.

Connecting to a Computer

When finished applying the settings, run EMP NS Connection on the computer, and
establish a connection with the projector. Once these settings have been established,
future sessions can begin by just connecting the devices.
Tip :
• Install the LAN card in the computer before starting EMP NS Connection. The LAN
card will not be recognised by the EMP NS Connection if the LAN card is installed
after EMP NS Connection is started.
• If you click on the "
with an explanation of the functions of that screen.
Procedure
1
Start Windows on the computer, then select "Start" - "Programs" (or "All
Programs") - "EPSON Projector" - "EMP NS Connection".
EMP NS Connection starts.
Tip :
If EMP NS Connection is started while PowerPoint is also starting, the message
"Slideshow may not start without rebooting PowerPoint", will be displayed during
startup. If this occurs, close PowerPoint and restart it once EMP NS Connection has
finished starting.
52
" icon of any EMP NS Connection screen, help will be displayed