Computer Connection Settings; Connecting To A Computer - Epson EasyMP EMP-7850 Guide De Mise En Route

Connecting Using Easy Connect Mode

Computer Connection Settings

Computer connection setup is performed using the utility software provided with
the wireless LAN card. If using Windows XP, no utility is necessary to
communicate in ESSID ad hoc mode. Utility software is necessary to communicate
using channel ad hoc mode. If these settings are already established, this step need
not be performed.
Refer to the documentation for the wireless LAN card for instructions on how to use
the utility software.
If the projector has been set to "ESSID
hoc mode on the computer.
If the projector has been set to "Channel
hoc mode on the computer. Set to the same ESSID or channel shown on the
Connection Stand-by screen on the projector.

Connecting to a Computer

When finished applying the settings, run EMP NS Connection on the computer, and
establish a connection with the projector. Once these settings have been established,
future sessions can begin by just connecting the devices.
Tip :
• Install the wireless LAN card in the computer before starting EMP NS Connection. The
wireless LAN card will not be recognised by the EMP NS Connection if the wireless
LAN card is installed after EMP NS Connection is started.
• Set the WEP
functionality.
• If you click on the "
with an explanation of the functions of that screen.
28
to OFF in either the wireless LAN card or for internal wireless LAN
" icon of any EMP NS Connection screen, help will be displayed
ad hoc", you must also select ESSID ad
ad hoc", you must also select channel ad