Epson EasyMP EMP-7850 Guide De Mise En Route page 51

Connecting in Access Point Mode or Wired LAN Connection Mode
Encryption key
* The item contents will be cleared if you select the "Clear" button on the selected
item and press [Enter] on the remote control.
Entering Letters and Numbers
Perform the following steps to enter letters and numbers.
1. Move the cursor to the item to input, and press the [Enter] button on the remote
control. The cursor turns green to indicate you are in input mode.
2. Press the [Num] button on the remote control to enter numbers only.
The [Num] button lights up and the remote control buttons change to numeric
keypad mode so that you can enter numbers.
To enter a period ( . ) press the [a] button from a space where characters can be
input.
period
50
Sets the key used for WEP encryption.
Input a key according to directions of the Network
Administrator for the network you wish to connect to.
The input of characters differs depending on the "WEP
encryption" and "Format" settings, as follows.
For "128bit"-"HEX": Up to 26 single byte characters, from
For "40bit"-"HEX": Up to 10 single byte characters, from 0-
For "128bit"-"Text1/2/3": Up to 13 single byte English
For "40bit"-"Text1/2/3": Up to 5 single byte English
Remote control
The buttons inside the box will
switch to numeric keypad mode
while the [Num] button is lit.
0-9 and A-F
9 and A-F
characters
characters
Numeric buttons