Turning The Projector On And Off - Epson BrightLink 450Wi Guide Rapide

Turning the Projector On and Off

Before you turn on the projector, turn on your computer.
1. Make sure the projector is plugged in. The Ppower light should be orange.
Power light
2. Press the Ppower button on the remote control.
After a few moments, you should see your computer desktop displayed. If you
see a blank screen or the
Warning:
Never look into the lens when the lamp is on. This can damage your eyes, and is
especially dangerous for children.
3. When you're finished using the projector, press the Ppower button on the
remote control.
4. When you see a confirmation message, press the Ppower button again.
Note:
Lamp life will vary depending upon mode selected, environmental conditions, and
usage. Turn off this product when not in use to prolong the life of the projector.
The projector can be set to automatically turn off the lamp and enter "sleep mode"
when it has not received any signals for 1 to 30 minutes (see your on-screen User's
Guide for details). This conserves electricity, cools the projector, and extends the life of
the lamp. If you want to start projecting again, press the P power button.
Power
button
No signal
message, see page 27 for help.
Turning the Projector On and Off
11