Epson EasyMP EMP-7850 Guide De Mise En Route page 30

Procedure
1
In Windows, select "Start" - "Programs" (or "All Programs") - "EPSON
Projector" - "EMP NS Connection".
EMP NS Connection starts.
Tip :
If EMP NS Connection is started while PowerPoint is also starting, the message
"Slideshow may not start without rebooting PowerPoint", will be displayed during
startup. If this occurs, close PowerPoint and restart it once EMP NS Connection has
finished starting.
2
The first time EMP NS Connection starts after installation, select the
wireless LAN card that will be used for the connection, and click "OK".
Tip :
• In the event that the IP address
the message, "Failed to obtain network adaptor infomation..." may be displayed. This
is because it takes time to determine the IP address, if the projector cannot connect to
the DHCP server. Please wait about 60 seconds and then repeat the process from
Step 1.
• Once the network adapter in use has been selected in this Switch network screen, this
screen will not be displayed at subsequent EMP NS Connection startups. To change the
current network adapter, click the "Extension" button in the Projector selection screen
(screen in Step 3). Click the "Switch LAN" button on the Extention screen to display the
Switch network screen.
has not been set in the projector's network settings,
29