Epson EasyMP EMP-7850 Guide De Mise En Route page 48

Mail
Mail Notification
Settings
IP address of
SMTP server
Port Number
Destination
address 1/2/3
Setting a
Notification
Event
* The item contents will be cleared if you select the "Clear" button on the selected
item and press [Enter] on the remote control.
Select "ON" to enable receipt of mail notification.
Enter the IP address of the SMTP server for the projector to
use.
Numbers between 0-255 can be entered in the address field.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0-255.255.255.255 (where x is a number
between 0-255.
Enter the SMTP server port number. The initial value is 25.
Numerical values from 1-65535 can be input.
A maximum of three destination email addresses can be
registered.
A maximum of 53 single-byte alphanumeric characters can
be input.
Selects the projector warnings/abnormalities to be notified
by mail. If the selected conditions occur with the projector,
the preset "Destination address" will be notified.
One or more of the following items can be selected.
• Internal error
• Lamp timer failure • Lamp out
• Lamp cover is open • Internal temperature error
• High-speed cooling in progress
• Lamp replacement notification
• No-signal
• Fan related error • Sensor error
47