Jet BD-3 Mode D'emploi page 6

Fig 13
9. Trouble shooting
Motor doesn't start
*Chuck guard open-
close chuck guard.
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
Machine vibration
*Unbalanced work piece-
Reduce spindle speed.
*Work piece deflection-
improve chucking length or diameter,
support on tailstock end.
*Tool deflection-
reduce tool length.
*Slide backlash-
adjust slide gibs.
*Slides running dry-
lubricate with oil.
*Dull tool tip-
resharpen or change tool.
*Chip load too high-
reduce depth of cut or feed-
Tool tip burns
*Cutting speed too high-
reduce spindle speed.
*Dull tool tip-
resharpen tool tip.
Machine turns a taper
*Machine bed is twisted-
supporting surface must be flat.
10. Environmental protection
Protect the environment.
Your appliance contains valuable
materials which can be recovered or
recycled. Please leave it at a
specialized institution.
11. Available accessories
Stock number 50000071
Turning tools 8x8mm, 11 pieces set
Stock number 50000072
Steady rest
Stock number 50000073
Longitudinal power feed
Stock number 50000074
Top slide
Stock number 50000075
2-way toolpost
Stock number 50000076
Live centre
Stock number 50000077
Wood toolrest with drive center
Stock number 50000078
Face plate Ø70mm
Stock number 50000079
8mm drill chuck (M14x1)
Stock number 50000909
Cutoff tool, 8x8mm
Stock number 50000919
Lathe dog ø10mm
8