Cleaning; Troubleshooting - CASO DESIGN VC 6 Mode D'emploi

► The sealing bar remains hot after use. Wait a few minutes until the bar has cooled
before cleaning.
► Clean the unit after every use as soon as it has cooled. Leaving the unit uncleaned for
long periods can make it very difficult to remove leftover food and grime and may even
damage the unit.
► If moisture penetrates the unit's housing, it can damage the electronic components.
Please ensure that no moisture enters the device.
► Do not use any harsh or abrasive cleaning agents.
► Do not attempt to scrape off stubborn grime with hard or abrasive tools.
► Dry all parts thoroughly before using after cleaning.
► Never immerse the device in water or other liquids and do not place in the dishwasher.

17.2 Cleaning

◆
Outside of the unit
Wipe the outside of the unit with a damp cloth or sponge and mild dish soap.
◆
Inside of the device
To clean the inside of the unit wipe away any food or liquids with a paper towel.
◆
Preservation bags
Washing the bagging material in warm water with a mild dishwashing soap, then rinse the
bags well and allow drying thoroughly before reusing
► Bags used to store raw meats, fish or greasy foods can't be reused.
◆
Sealing profile (which presses the bag against the sealing bar)
Remove the sealing profile and clean it in warm soapy water.
► The sealing profile should be cleaned thoroughly before installing it again.
► Be careful during re-installation, so that nothing will be damaged and sealing profile is
placed well so that the device can work properly.

18 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
Chasse
Attention
Attention
Please note
Pêche
.
Loisir et nature
www.ducatillon.com
Jardin
40
Élevage