Installing The Thermometer; Placing The Grease Bucket; Installing The Cooking Components - Pit Boss PB440TG1 Instructions

• On the non-hopper side of the main barrel, repeat same installation
for the barrel handle. Note illustration 5B.
NOTE: Use the barrel handle to move the grill when the unit is
expanded into its full, upright position.

6. INSTALLING THE THERMOMETER

Parts Required:
1 x Thermometer Kit (#3)
Installation:
• Remove the pre-installed nut from the thermometer. Insert the
thermometer into the hole provided on the top of the lid on the main
barrel, then secure by re-installing the nut from the inside. Rotate the
thermometer so the text is level and upright.
NOTE: If rotation is askew, this will result in incorrect readings.

7. PLACING THE GREASE BUCKET

Parts Required:
1 x Grease Bucket (#13)
Installation:
• Place the grease bucket on the spout hook on the end of the main
barrel. Ensure it is level to avoid grease spills.

8. INSTALLING THE COOKING COMPONENTS

Parts Required:
Cooking Grids (#2)
2 x
1 x Upper Cooking Rack (#1)
1 x Flame Broiler Main Plate (#8)
1 x Flame Broiler Slider (#7)
Installation:
• Insert the flame broiler main plate into the main grill. Rest the flame
broiler main plate on the built-in ledge (on the inside right) of the
main grill that directs grease towards the grease bucket. Slide the
entire piece to the left side, and the two slots on the flame broiler
main plate will fit into the rounded ledge above the fire pot. It will sit
slightly at a downward angle. Note illustration 8A.
NOTE: If the main plate is on the base of the barrel, it is installed incorrectly.
• Place the flame broiler slider on top of the flame broiler main plate, covering
the slotted openings. Ensure the raised tab is on the left, to easily adjust
for direct or indirect flame when cooking. Note illustration 8B. Both flame
broiler parts are lightly coated with oil to avoid rusting when shipped.
NOTE: When the flame broiler slider is open, and direct flame is used
while cooking, do not leave the grill unattended for any period of time.
• Place the cooking grids, side-by-side, on the grid ledge inside the main grill.
• The unit is now completely assembled.
NOTE: To maintain the searing and grilling performance of your
cooking grids, regular care and maintenance Is required.
5B
6
7
8A
8B
9