Installing The Cooking Components; Placing The Grease Bucket; Connecting To A Power Source - Pit Boss PRO Série Manuel D'installation Et Fonctionnement

12. INSTALLING THE COOKING COMPONENTS

Parts Required:
1 x Upper Cooking Rack (#1)
2 x Cooking Grids (#2)
Installation:
• Place the cooking grids, side-by-side, on the grid ledges inside the
main barrel. Place the upper cooking rack on the upper ledge inside
the main barrel. The cooking rack will lock into place.
NOTE: To maintain the searing and grilling performance of your
cooking grids, regular care and maintenance is required.

13. PLACING THE GREASE BUCKET

Parts Required:
1 x Grease Bucket (#15)
Installation:
• Place the grease bucket on the spout hook on the end of the main
barrel. Ensure it is level to avoid grease spills.
• The unit is now completely assembled.

14. CONNECTING TO A POWER SOURCE

STANDARD OUTLET
•
This appliance requires 110-120 volt, 60hz, 250w. It must be a 3-prong
grounded plug. Ensure grounded end is not broken off before use. The
control uses a 110-120 volt, fast-blow fuse to protect the board from
the ignitor.
GFCI OUTLETS
•
This appliance will work on most GFCI outlets, with a recommended
size of 15 amp service. If your GFCI outlet is highly sensitive to power
surges, it will likely trip during the start-up phase of operation. During
the start-up phase, the ignitor draws 200-700 watts of electricity
which can be too much power for a GFCI outlet to handle. Each time it
trips, it increases in sensitivity. If the GFCI keeps tripping, replace the
outlet or change to a non-GFCI outlet.
• ON THE ROAD
Disconnect the ignitor from the main wiring harness. Use the manual
start-up procedure. A Pit Boss® unit can operate using a 12 volt,
100 watt inverter plugged into your automobile outlet. To use the
automatic ignitor, it is recommended to use a minimum of a 1000
watt inverter.
IMPORTANT: Disconnect unit from power source when not in use.
12
12
1
2
13
15
14