Disassembly And Disposal - Maico PP 60 KA Instructions De Montage Et Mode D'emploi

gb | 13. Disassembly and disposal
filter change display on the room air
control reports that the filters need
changing:
● LEDs of set operating mode and
ventilation level flash, for example:
WARNING
Danger from electric shock!
Deactivate the fuse in the fuse box and
protect against being accidentally switched
back on. Fit a warning notice on the fuse
box.
1. Take off internal cover [9] of
ventilation unit.
2. Remove internal filter [6].
3. Use wire sling to take out slide-in
module [4] including heat exchanger
and EC fan.
4. Remove external filter [4].
5a. When cleaning filters: blow out both
filters with compressed air, working
from inside to outside of filter.
5b. When changing filters: take two new
filters out of the packaging.
6. Place external filter [4] on slide-in
module [5] and turn down pasting
lugs. The pasting frame must be
facing the slide-in module.
7. Place internal filter [6] on slide-in
module [5] and turn down pasting
lugs. The pasting frame must be
facing the slide-in module.
40
8. Slide slide-in module [5] into wall
insulation sleeve. The heat exchanger
must be facing you.
9. Seal ventilation unit with internal
cover [9].
 You will hear it engage.
10. Activate mains fuses and remove
warning sign.
 Start the ventilation units.
12.2 Cleaning the internal cover
WARNING
Danger from electric shock!
Deactivate the fuse in the fuse box and
protect against being accidentally switched
back on. Fit a warning notice on the fuse
box.
1. Take off internal cover [9] of
ventilation unit.
2. Clean internal cover with damp cloth.
Make sure that no water enters the
ventilation unit.
3. Seal ventilation unit with internal
cover.
 You will hear it engage.
4. Activate mains fuses and remove
warning sign.
 Start the ventilation units.

13. Disassembly and disposal

Packaging
Dispose of the packaging material in
compliance with the regulations valid in the
country where you are.