Installing The Temperature And Moisture Sensor - nVent RAYCHEM EM4-CW Manuel D'installation

INSTALLING THE TEMPERATURE AND MOISTURE SENSOR

Install the temperature and moisture sensor in
accordance with the instructions supplied with
the unit. Ensure that it is supported at the correct
height.
Heating
cable
50
50 mm
mm
• The sensor lead should be routed under the
layer with the heating cable.
• The sensor should be placed mid-way between
heating cable runs.
Concrete, asphalt
or paving bricks
= =
50
50 mm
mm
Sensor
Sensor housing
Heating
cable
Conduit
• The sensor lead should be protected by a
conduit (4).
Sensor
Surface Sensor
• The sensor must be mounted vertically, even
on inclined surfaces.
Filling material
Sub surface
nVent.com | 15