Installing The Flight Battery; Center Of Gravity; Transmitter Control Identifi Cation - Horizon Hobby E-Flite Blade SR Manuel D'utilisation

Installing the Flight Battery

Use the included hook and loop material for mounting the Li-Po battery pack. We suggest installing the loop (fuzzy) material on the
battery pack and the hook material on the battery support. You should also use the included hook and loop battery strap for the most
secure attachment of the battery to the helicopter.

Center of Gravity

Once you have properly installed and secured the battery, check the helicopter's center of gravity. With the canopy installed, lift the
helicopter by the fl ybar with the fl ybar positioned perpendicular to the tail boom. Move the battery forward or rearward as required to
achieve a slightly nose down or perfectly level helicopter position. You should always check the CG of your Blade SR before fl ying,
especially if you are switching between different sizes and types of battery packs.
Level or Slightly
Downward Angle
Transmitter Control Identifi cation
WARNING: Before each fl ight ALWAYS turn the transmitter on before connecting the fl ight battery to the 2-in-1 unit. After each
fl ight, ALWAYS disconnect the fl ight battery from the 2-in-1 unit before powering the transmitter off.
STICK Mode 1 Mode 2
Rudder A
Throttle B
Aileron B
Elevator A
A
A
A
B
B
C
Support by Flybar
B
D E
F
7
TRIM Mode 1 Mode 2
Rudder C
Throttle E
Aileron F
Elevator D
C
D
F
E
EN