Installing The Flight Battery; Control Test - Horizon Hobby Revolution ASCENT MTX Manuel D'utilisation

EN

Installing the Flight Battery

1. Make sure the throttle is in the off position and
turn on the transmitter.
2. Open the battery hatch on the bottom of the
aircraft and plug in the flight battery.
3. Install the flight battery into the aircraft as shown
and close the hatch.
4. Power on the aircraft.
1

Control Test

CAUTION: Keep away from the propellers, they will spin up
during the control test.
The Ascent MTx aircraft relies on motor thrust to climb, descend and
™
turn. Always perform a control test before flight to ensure the motors
are working properly.
1. Turn the aircraft on as shown
above.
2. Turn the transmitter on.
3. Hold the aircraft so it does not
escape your control.
4. Arm the motors by first moving
the left stick to 100% and then
back down to 0%.
5. Move the sticks on the
transmitter to ensure the
motors respond as shown.
Tip: To check the Left and Right
turn, keep the throttle at 0% and
note which motor spins.
If the motors do not react as
shown, refer to the Binding
instructions and Troubleshooting
Guide in this manual.
battery from the aircraft when not flying to avoid
over-discharging the battery. Batteries
discharged to a voltage lower than the lowest
approved voltage may become damaged,
resulting in loss of performance and potential fire
when batteries are charged.
2
Arm the motors
Turn Left/ Right motor spins
6
CAUTION: Always disconnect the flight
CAUTION: Keep away from the propellers.
3
Throttle on (100%)
Turn Right/ Left motor spins
4