Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CONVERSION
PRESSURE REGULATOR CONVERSION
The appliances is designed for use with NG gas or LP gas. The rating label will identify which
gas the appliance is configured for. For use with a different gas, the orifices must be changed
and the regulator must be converted.
To convert the pressure regulator, follow the below instructions:
•
Disconnect all electrical power, at the main circuit breaker or fuse box.
•
Shut off the gas supply to the cooktop by closing the manual shut-off valve.
Convert the pressure regulator as follows: (see figure 24)
1) Unscrew the regulator cap
2) Unscrew the plastic conversion plug from the cap turn over and screw back (wide section
away from cap for LP and against cap for NG).
3) Replace the regulator cap.
FLAME CHECK
After replacing orifices and converting
the pressure regulator, check/adjust
all burner flames according to «FINAL
SETUP» on page 22 and «Burner
Adjustment» on page 24.
Check the appearance of each burner
flame on the HI-LO settings, if the
flame seems too big or small, check
if the steps have been followed
correctly.
(continued)
NG POSITION
Before replacing the regulator cap, confirm that the
plug is correctly positioned for the gas to be used.
Figure 24. Converting the Regulator
LPG/PROPANE
POSITION
©2019 Hestan Commercial Corporation
EN
21
Publicité
Table des Matières
