Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CONVERSION
REPLACING ORIFICES ON STACKED BURNER (KGC36)
1) Remove the grates and burner caps (A).
EN
2) Remove gas spreader (B).
3) Loosen orifices (C) by turning 9/32" nut driver
counter-clockwise.
4) Install the orifices supplied with this appliance in
the appropriate burner. Each orifice has a number
stamped on the side, which identifies the orifice
diameter. (See Figure 23 for the orifices to use in
each burner position).
5) Turn clockwise to tighten. Tighten to a torque of
15 to 20 inch-lbs. [1.7-2.3 N-m].
6) Replace all parts following the reverse order.
7) Save the orifices removed from the appliance for
future use.
1.5
1.3
0.54
1.75
0.54
1.75
Figure 23. Orifice Locations
20
©2019 Hestan Commercial Corporation
(continued)
N
G
MAIN FLAME SIMMER
0.75
1.45
1.45
MAIN FLAME SIMMER
1.45
1.45
0.75
C
Figure 22. Stacked Burner
KGC 30 Orifices
1.5
.094
1.3
0.72
KGC 36 Orifices
0.37
0.54
1.10
1.75
0.37
0.54
1.10
1.75
A
B
L
P
c
o
n
e v
s r
o i
n
MAIN FLAME SIMMER
0.85
0.85
0.5
MAIN FLAME SIMMER
0.5
0.85
0.85
0.94
0.72
0.37
1.10
0.37
1.10
Publicité
Table des Matières
