hestan KGC30 NG/-LP Manuel D'installation page 13

Masquer les pouces Voir aussi pour KGC30 NG/-LP:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

LOCATION AND INSTALLATION
Step 3
Insert the cooktop centered into the cutout
opening.
Make sure the front edge of the counter top is
parallel to the cooktop. Make final check that all
required clearances are met.
Step 4
Four clamp brackets are provided with your unit.
After cooktop has been installed into the
countertop, install the brackets on the burner box as
shown in Figure 14 .
Install the clamp brackets on the front and back of the burner box bottom (if the cabinet
construction does not provide clearance for installing brackets at the front and back of the burner
box, install the clamp brackets on the sides of the burner box).
Step A: place the clamping screws into brackets
Step B attach brackets by using the attachment screws on the selected location of burner box,
tighten screws just enough to hold brackets in place
Step C: position brackets so that each clamp screw is in contact with the counter top bottom
Step D: tighten attachment screws securely.
Step E: check that the front edge of the cooktop is parallel to the front edge of the countertop
tighten the clamping screw against the countertop.
DO NOT OVER TIGHTEN
Figure 14. Install and Secure Clamps
(continued)
Figure 13. Place Cooktop
©2019 Hestan Commercial Corporation
EN
11

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Kgc36 ng/-lpKgc serieKgc30 ngKgc30 ng-lpKgc36 ng

Table des Matières