Operating The Device - ProMed INH-2.1 Instructions D'utilisation

OPERATING THE DEVICE

Checking/replacing the battery
To replace/insert the batteries, put 2 batteries 1.5V AA (O) into the battery compartment (M) by
opening the battery compartment cover (N). Ensure that the batteries are inserted with their right
polarity (+/-). After inserting, close the battery compartment again. Promed INH-2.1 checks the
charge status of the batteries. If the capacity of the batteries is low, the battery status LED (H) flashes
orange. If this is the case, the batteries must be replaced immediately as otherwise a correct function
of the Promed INH-2.1 is not given anymore.
Caution:
1. Remove the batteries when the device is not used for a longer time.
2. Do not use old and new batteries or different battery types at the same time.
3. Warning: If batteries leak and come in contact with skin or eyes, immediately clean these areas
with plenty of water.
4. Batteries shall only be used by adults. Keep the batteries out of the reach of children.
5. It is recommended to use batteries of the same or similar type.
6. Remove empty batteries from the device.
7. Dispose of the batteries according to the instructions of the battery manufacturer.
8. Do not use batteries when they have expired.
DE
Commissioning of the device
Before using the device ensure that all components are clean and dry.
EN
A. Removing the medicament holder from the main device
To remove the medicament holder (B) from the main device (A), press the
locking button (I) and carefully pull the medicament holder off of the main
FR
device.
Caution!
IT
1. To avoid damages to the device it is important to press the button before pulling the medicament
holder.
2. To avoid damages to the mesh membrane (P), leave the protective cap (C) on the medicament
holder until a mouthpiece or an inhalation mask is inserted.
ES
B. Filling the medicament holder
To fill the medicament holder, flap the cover (J) of the holder upwards. To
NL
do so, you have to flap the locking (K) upwards first. Now you can fill the
holder with the desired liquid. Please ensure that you fill min. 0.5ml and
max. 8ml. After filling, close and lock the cover by flapping the locking
downwards until it clicks into place.
RU
Caution!
1. To avoid the leakage of the medicament holder, ensure that the fastening of
PL
the cover has clicked correctly into place.
2. Never fill the medicament holder when it is attached to the main device.
C. Attaching the medicament holder to the main device
TR
Before reconnecting the medicament holder with the main device, check
that the contact pins (L) of the main device and the medicament holder are
clean and dry. Now carefully place the holder onto the device and push it
AR
backwards until it clicks into place. You must hear a "click".
24