Connect To Water Supply; Connect To Drain - IKEA IUD9500W Instructions D'installation

Option 2: Power Supply Cord
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug in a grounded 3 prong outlet.
2. Check that power supply cord does not touch dishwasher
motor or lower part of dishwasher tub.

Connect to Water Supply

Helpful Tip:
Compression fittings:
a) Slide nut onto copper tubing about 1" (2.5 cm).
b) Slide ferrule onto the tubing. Do not position ferrule on
the end of the tubing.
c) Put the tubing into the elbow as far as it will go.
d) Slide the nut and ferrule forward and start the nut onto the
elbow threads. Be gentle when handling and positioning
the copper tubing, it bends and kinks easily.
A
1. To avoid vibration during operation, route the water supply line
so that it does not touch the dishwasher base, frame or motor.
2. With copper tubing pushed into compression fitting as far as it
will go, use a wrench and tighten compression fitting nut to
elbow on water inlet valve.
3. Place paper towel under elbow. Turn on water supply and
check for leaks.
18
All manuals and user guides at all-guides.com
C
B
A. Elbow
B. Ferrule
C. Nut

Connect to Drain

1. To help minimize vibration, route drain hose to avoid contact
with motor, door springs, water line, cabinet, flooring or the
edge of the hole where it passes through the cabinet.
2. Do not remove drain loop from side of dishwasher.
3. Place pan under end of drain hose. Pan will collect any water
in drain hose.
4. Place the smaller drain hose clamp onto the small end of the
drain hose.
A
A. Hose clamp
5. Push the drain hose into the connector up to the stop on the
drain hose.
A
A. Connector
B. Stop
6. User pliers to open clamp and slide clamp onto connector
between stops on connector as shown.
A
A. Hose clamp
B. Stops
A
A. Drain loop
B
B