Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Install Moisture Barrier
(on some models)
1. Make sure the area under the cabinet is clean and dry for
installation of the moisture barrier.
2. Remove the backing of the moisture barrier and apply to
underside of the countertop along the front edge of the
counter.
A
A. Moisture barrier
Prepare Dishwasher
WARNING
Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
1. Put corner posts from packaging behind dishwasher. Grasp
sides of dishwasher door frame and put dishwasher on its
back, resting on top of the corner posts.
All manuals and user guides at all-guides.com
2. Remove two screws attaching access panel and lower panel
to dishwasher using a ¹⁄₄" hex socket, nut driver or Phillips
screwdriver.
A
B
A. Access panel
B. Lower panel
C. Grounding clip
3. Remove panels and set panels aside on a covered surface.
4. Check that grounding clip is attached to the lower panel.
®
5. Apply Teflon
tape or pipe joint compound to 90° elbow fitting
and connect fitting to water inlet valve.
6. Tighten elbow until snug, and be sure that it faces to the rear.
A
A. Water inlet valve
B. Elbow
7. Remove terminal box cover.
■
If you are direct wiring: install a UL-listed/CSA certified
clamp connector to the terminal box. If using conduit, use
a UL-listed/CSA-certified conduit connector.
C
B
11
Publicité
Table des Matières
