Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
A A
B
2. Gently set outer panel aside.
3. Lay the customer-supplied custom panel face down on a
covered, non-scratching surface.
4. Measure 9²⁹⁄₃₂" (25.2 cm) from top edge and mark a line on the
back of customer-supplied custom panel.
A. Mark line
B. Top edge
5. Position the outer panel on the back of the customer supplied
custom panel as shown, so that the top holes in the outer
panel are on the line, and both panels are centered side to
side.
6. Mark all four hole locations; remove outer panel. Drill ³⁄₃₂" pilot
holes ¹⁄₂" (13 mm) deep in customer-supplied custom panel.
A. Mark pilot holes
7. Place the outer panel on the back of the customer-supplied
custom panel. Align holes.
8. Attach outer panel to back of customer-supplied
custom panel with the four #10-16 x ³⁄₈" hex head
screws supplied in the package containing
literature.
14
All manuals and user guides at all-guides.com
A
A.Screws
B.Outer panel
A
29
9
/
"
32
(25.2 cm)
B
A
9. Attach the handle. The handle should be centered on the front
of the customer-supplied custom panel in the area shown.
A
A. Handle location
10. Attach the panel assembly to the door by reinstalling the three
screws on each side; do not tighten completely. This will hold
the panel assembly in place on the door frame.
11. Align the top edge of the customer-supplied custom panel
with the top of the console.
12. Drill two ³⁄₃₂" pilot holes ¹⁄₂" (13 mm) deep, into the customer-
supplied custom panel, through the holes in the top corners of
the inner panel as shown.
A. Inner panel
B. Align top edges
C. Drill through these holes
13. Install the two #8-18 x 1³⁄₈" screws from the literature package
in the top corners of the inner panel.
14. Tighten the six side screws reinstalled in Step 10.
Choose Attachment Option
WARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
Using two or more people stand the dishwasher up.
Option 1: Countertop
The dishwasher must be secured to the cabinet. There are two
brackets on top of the dishwasher that can be attached to the
countertop if it is wood, laminate or other similar surfaces. If your
countertop is marble, granite or other hard surface the brackets
may be moved to the sides of the dishwasher.
6"
(15.2 cm)
A
C
B
Publicité
Table des Matières
