Move Dishwasher To Final Location; Level The Dishwasher - IKEA IUD9500W Instructions D'installation

5. Reattach door spring to rear leg. Tensioners on both sides of
dishwasher should be secured at same holes.
A
A. Screw
B. Tensioner
C. First hole location (lower setting)
D. Second hole location (medium setting)
E. Third hole location (higher setting)

Move Dishwasher to Final Location

WARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
1. Grasp the sides of the dishwasher at the edges of the door
panel.
2. Tilt dishwasher backwards on wheels and move dishwasher
close to cabinet opening. Do not push on the front of the
panel or on the console—they may dent.
3. If dishwasher has a power supply cord, insert power supply
cord into hole cut into cabinet. If using direct wire, check that
it is on the right front side of opening.
4. Check that water line is on the left side of opening and drain
hose is near the center of the hole in the cabinet.
5. Slowly move dishwasher
completely into cabinet
opening. Do not kink or pinch
copper tubing, drain hose,
power supply cord or direct
wire between dishwasher and
cabinet.
Helpful Tip: Once the
dishwasher is in position, you
may have to support the front
of the dishwasher by raising,
lowering or shimming front feet.
6. Remove cardboard from under dishwasher.
NOTE: It is all right if dishwasher fits tightly into cabinet
opening. Do not remove insulation blanket —the blanket
reduces the sound level.
16
All manuals and user guides at all-guides.com
A
A. Spring
B
C D E

Level the Dishwasher

1. Align front of dishwasher door panel with cabinet doors. You
may need to adjust alignment to be even with your cabinets.
Helpful Tip: Prop up one side of frame to hold dishwasher up
off floor when adjusting front legs.
2. Check that leveling legs are firmly against the floor.
3. Close and latch the door, and place level against the front
panel. Check that dishwasher is plumb. If needed, adjust
leveling leg or add shims under rear wheel until dishwasher is
plumb.
4. Repeat for other side of the dishwasher.
NOTE: Make sure the shims are securely attached to the floor.
This will hold the shims in place when dishwasher is being
operated.
5. Place level against top front opening of tub. Check that
dishwasher is level from side to side. If dishwasher is not level,
adjust front legs up or down until dishwasher is level.