R&G LP0214BK Instructions page 6


From the kit, take the R&G license plate bracket (item 4) and fit both OEM indicators just
removed to the licence plate as original (shown in picture 12).
IF fitting R&G Mini indicators:

From the kit take the mini indicator adaptors ( Item 5) and locate the two plates together
as illustrated in exploded diagram above.
Page | 6

Fit the R&G Mini Indicator through the hole with the slot.

Fit the bullet connectors on the R&G indicator and Indicator connectors (Item 13) as
follows:

If fitting R&G Aero Indicators with LED's

If fitting R&G Mini Indicators with bulbs

If fitting R&G Mini Indicators with LED's

Fit one length of heat shrink supplied (item 15) to protect the indicator wiring on both
indicators.

From the kit, take the R&G License plate Illuminator (Item 7) and place it through the
three in-line holes in the centre of license plate bracket (item 4) as shown in picture 13.
Secure the license plate illuminator using M3 washers and nuts provided in the kit. Apply
a little amount of super glue around the top surface of the license plate illuminator (Item
7) and place the license plate illuminator shroud (item 8) over.

Feed the license plate illuminator wires through one of the heat-shrink tube (item 15)
provided and using a suitable heat resource, shrink the tube to protect the wires.

From the kit take the Rubber bung (item 11), O-ring (Item 10) and cover plate (Item 6).
Locate the O-ring into the Rubber bung. Locate the rubber bung and O-Ring assembly
into the provided hole in the cover plate (Item 6) (O-ring to sits below the cover plate),
shown in Picture 14.

Feed all the wires (License plate illuminator & indicators wiring) through the rubber bung
from below and locate the cover plate assembly on top of the R&G license plate bracket
as shown in Picture 15.

Offer the whole assembly towards the sub-frame and feed the wires as original. Secure
the assembly onto the sub-frame using M6 bolts (Item 1), M6 washers (Item 2) and M6
nyloc nuts (Item 9). Note: Washers to be located as illustrated in exploded diagram
above. Tighten the nuts to 15Nm.

From the kit take the licence plate illuminator connector (Item 12) and connect the male
connector to main loom as original. Connect the bullet connectors in this scheme:
If the license plate illuminator fails to illuminate, please swap the connectors around.

Connect the Indicator connectors to the main loom as original.

Check all the lights for correct operations.

Tidy the wiring using the cable ties (Item 14) provided.

Re-fit the OEM undertray as original.

Re-Fit the rear panels/ bodywork as original.

Fit a licence plate to new licence plate bracket (it may require re-drilling
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
Indicator Yellow -----------------
Indicator Black ------------------
Indicator Black/white ------------
Indicator Black -------------------
Indicator Black/white ----------
Indicator Black -----------------
Illuminator Red ---------------------
Illuminator Black -------------------
R&G Racing
www.rg-racing.com
6

Indicator Connector Green

Indicator Connector Black

Indicator Connector Green

Indicator Connector Black

Indicator Connector Green

Indicator Connector Black

wiring loom Red

wiring loom Black
Email: info@rg-racing.com