Publicité
Les langues disponibles
Les langues disponibles
Finally...
1
2
3
4
All manuals and user guides at all-guides.com
(6)
(7)
(9)
Close left side panel
Return device to its original position
Insert wirespool or basket-type spool
Restore connections to other system components
Plug the welding torch connection (and
6
adapter) from front to back into the wel-
ding torch mounting as shown
Route the welding torch connection ca-
7
ble (6) into the corresponding grooves
(7) as shown
Connect the welding torch connection
8
plug (8) to the device
NOTE!
In the following step, ensure that no ca-
bles are trapped between the welding
torch connection and the motor plate
(9).
(8)
Push the welding torch connection into
9
the device as far as it will go
Close the clamping lever (10)
10
Only when fitting FSC:
11
Connect the welding torch to the de-
vice (this step is not necessary for all
other connection types)
Refit and tighten the two TX25 screws
12
to the welding torch connection on the
front of the device
-
Tightening torque = 3 Nm
(10)
13
Publicité
