Troubles And Solution - Oceanic OCEACLIM140W1 Guide D'utilisation

The following cases are not always dysfunctional.
Check before contacting customer service.
Problem
Does not work
Works just moments
Works but does not cool
Does not work and the water
indicator lights up.
The machine is noisy or
vibrates.
The device makes a noise
"Gurgling".
The remote control does not
work
VII. TROUBLES AND SOLUTION
-The circuit breaker or fuse is blown.
-Wait 3 minutes and turn on the appliance again.
The breaker may be preventing the unit from operating.
-The batteries of the remote control are discharged.
-The plug is not connected correctly.
-If the set temperature is close to the room temperature, you
can decrease the set temperature.
-Output of air blocked by an obstacle. Remove this
obstacle.
-Door or window be opened.
-Another heater works (heating, lamp, etc.)
-The air filter is dirty, clean it.
-Output or air intake clogged.
-Temperature set too high.
-Ventilation speed too low, selected higher ventilation
speed.
-Drain the water into a container using the drain hose on
the back of the appliance.
If the unit still does not work, consult a qualified
technician.
The device is not placed on a flat surface. Always install
the appliance on a flat, stable surface.
This is normal. This is the sound of the refrigerant gas
circulating inside the device.
Ensure that the distance between the remote and the unit
is not too important.
-Ensure orient the remote control to the air conditioner.
-Ensure that there are no obstacles between the remote
control and the air conditioner.
-The remote-control batteries are exhausted. Replace
them.
Soloution
69