Cleaning And Maintenance; Appliance Maintenance - Oceanic OCEACLIM700W1 Guide D'utilisation

CLEANING ANDMAINTENANCE
Caution:
turn off the appliance first before
disconnecting from power supply

Appliance maintenance

- Cut off the power supply.
W
- ipe the appliance with a soft and dry cloth. Use
lukewarm water to clean if the appliance is verydirty.
N
- ever use volatile substances such as gasoline or
polishing powder to clean the appliance.
N
- ever sprinkle or pour water directly into the main unit
Air filter maintenance
It
is necessary to clean the air filter after using it for about
100 hours. Clean it as follows:
S
- witch off the appliance and remove the air filter
located at the back of the air conditioner.
C
- lean and reinstall the air filter in the dedicated
compartment.
If it is really dirty, wash the appliance with a solution of
detergent in lukewarm water. After cleaning, dry it in a
shaded and cool place, then reinstall it.
C
lean the air filter every two weeks if the air conditioner
operates in an extremely dusty environment.
Water Drainage
D
uring the cooling and dehumidifying process, the
appliance extracts humidity from the atmosphere and
keeps the condensed water in an internal recycling tank
inside the appliance. When the water tank is full, the
appliance will:
- display an "E4" code
- stop operating until the water is emptied from the
appliance
W
ater can be drained in this ways:
1. Automatic drainage
T
his allows water to continuously drain out while the
appliance is operating. There is no need to turn it off in
order to drain. But the following connection work should
be performed at installation, before the appliance is turned
on.
P
- lease remove the plug of the drainage port.
C
- onnect the opening to a 10mm diametered drainage
pipe (not provided)
E
- xtend the pipe to a bucket or a drainage ditch
S
- witch the appliance on
W
ith this setup in place, all water produced during
operation will be drained out continuously. No manual
drainage work is needed after use.
If
automatic drainage is not employed, please ensure to
secure the secondary drainage port with the plug
provided.
2. M anual drainage via (primary drainage port)
T
his manual procedure is needed if automatic drainage
detailed above is not employed.
P
- lace the appliance near a drainage ditch
R
- emove the plug of the primary drainage port
T
- ilt the appliance slightly to pour water out
R
- e-plug the primary drainage port after drainage
Appliance not in use
P
- erform water drainage as instructed above.
T
- urn on the fan for a few hours to dry the inside of the
appliance. It dehumidifies the inside of the appliance,
and thus prevents the formation of any mould.
- Stop the appliance and take the power supply plug out.
T
hen take out the battery of the remote control and
store the appliance properly.
C
- lean the air filter and reinstall it.
- Remove the air hoses, store them properly, and cover
the holes tightly.
Warning:
K
eep the appliance at least 1 meter away from your
television or radios
interference.
D
o not expose the unit under direct sunlight to avoid
surface colour fading. Do not tilt the unit for more than
35°or put it upside-down during transportation. Place
the unit on a flat surface with less than 5° inclination.
E
mpty the condensation drainage pan before putting
the unit in storage at the end of the season, to prolong
the unit lifetime.
D
o not use chemical solvents (e.g. Benzene, alcohol-
glazer) to clean the unit to avoid scratching or damaging
the surface.
M
ake sure to cut off the power before disassembling or
installing the air-inlet fence.
P
lease empty the water from the water tank if you want
to move the machine. The battery must be removed
from the appliance before it is disposed of.
T
he battery is to be disposed of safely.
T
he plug must be removed before cleaning, maintaining
or filling the appliance.
EN-1 6
to avoid electromagnetic