Cooling Mode - Oceanic OCEACLIM140W1 Guide D'utilisation

COOLING MODE

Press the MODE button to select the Cooling mode .
The corresponding light is illuminated on the control panel.
-The air is then cooled and the hot air is discharged to the outside via the exhaust hose.
-In cooling mode, the discharge of the hot air must be to outside (see paragraph on
installation).
-Adjust the speed with the button
High : Medium : Low :
It is possible to use the continuous
drain to drain the collected water.
Set the target temperature you want. Use the increase and decrease of the control panel or
remote control. The temperature can be adjusted 16 ° C to 31 ° C.
Cooling is stopped when the room temperature is lower than the target temperature.
However, continuous ventilation to operate at the set level. Cooling starts again when the
room temperature exceeds the target temperature.
For maximum comfort, it is advisable to set your device up to 8 ° C below the outside
temperature on the day and 5 ° C below the outside temperature at night. So, you can save
energy and avoid operating the unit at full power.
DEHUMIDIFY MODE
-Press "MODE" button until the LED Deshu lights on.
The air is dehumidified as it passes through the device. The moisture removed from the air
is collected in the internal water tank.
The unit will automatically operate in fixed speed ventilation and temperature not ajustables.
- Keep windows closed and doors for better efficiency déshumidification.
- Do not use the exhaust hose to the outside.
It is possible to use continuous drainage for
discharging the collected water.
64